Connecting up the foot pedal
The MC1000 supports three types of throttle inputs (0 – 5v Hall Effect), The traditional potbox, and the HEPA throttle
I figured out the BMW had a HEPA throttle (some how)
The wiring colours are as follows;
1 Yellow (5v+)
1 Yellow/Green (5v+)
1 Brown (Ground)
1 Brown (Ground)
1 White/Yellow (signal) (0.4 – 2v)
1 White (signal) (0.7v – 4v)
Using a 5 volt power supply I hooked up the two yellows to 5v+ and two browns together to Ground, ,and tested the the voltage between each white and ground. I was getting a small voltage change on the meter. All good!
The BMW throttle had issues with this controller, the voltages were wrong. So I got a HEPA throttle from a 2009 Prius. The Prius throttle is designed to work with the MC1000 Controller.
The wiring pins are below (2009 Prius)
Pin 6 – Wiper 1
Pin 5 – Ground
Pin 4 – 5v +
Pin 3 – Wiper 2
Pin 2 – Ground
Pin 1 – 5v +